VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
- 8. Ignition system
   8.1. General description and work of system of ignition
   + 8.2. Main knots and details of system of ignition
   8.3. Precautionary measures at work on repair of system of ignition
   + 8.4. Work on repair and service of system of ignition
   + 8.5. Distributor of ignition of the 2,0-liter engine
   8.6. Adjustment of the moment of ignition of the 2,0-liter engine
   + 8.7. Spark plugs
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Ignition system>> Adjustment of the moment of ignition of the 2,0-liter engine
Ignition of the 2,0-liter engine is regulated, when the engine idles. Adjustment is understood first of all as the correct position of the distributor of ignition as it defines the ignition moment. For check on the car of the moment of ignition on the case of a flywheel there is a scale with a uvula and a label on a flywheel. One division of a scale corresponds 1 ° turn of a cranked shaft. At label combination on a flywheel with a uvula the piston of the first cylinder is in VMT.
Adjustment of the moment of ignition carry out in the following order:
- check engine idling;
- connect a clip «+» a stroboscope to the plug «+» AB, a "weight" clip — with the plug «–» AB, and a clip of the sensor of a stroboscope attach to a wire of VN of the first cylinder;
- start the engine and send a blinking stream of light of a stroboscope to the hatch of the case of a flywheel. When idling engine the provision of a label on a flywheel should be in limits from 5 ° to 8 °;
- if it is required to carry out adjustment of the moment of ignition, weaken fastening of the distributor of ignition and turn it so that the moment of ignition made 6 °;
- tighten fastening of the distributor of ignition and again check installation of the moment of ignition;
- disconnect stroboscope clips.
More exact installation of the moment of ignition can be carried out only by means of the special equipment on HUNDRED.