VW Sharan repair. Diesel engines: 1,9 l of TDI.+ 1. Introduction + 2. VR6 engine + 3. Two-liter engine (ADY) + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of the VR6 engine + 7. Simos system of injection of fuel of the 2,0-liter engine + 8. Ignition system + 9. Coupling + 10. Mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. Hydraulic booster of a steering - 13. Forward suspension bracket 13.1. Removal and installation + 13.2. Repair of a forward suspension bracket 13.3. Stabilizer of cross-section stability - 13.4. Adjustment of corners of installation of forward wheels 13.4.1. Convergence of wheels 13.4.2. Corner of disorder of a wheel 13.4.3. Corner of a longitudinal inclination of an axis of turn + 14. Back suspension bracket + 15. Brake system + 16. Electric equipment + 17. Diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. Power supply system of the diesel engine and turbokompressor + maintenance Card + Specifications and characteristics + Elektroskhema |
Repair Sharan/Sharan Volkswagen>> Forward suspension bracket>> Adjustment of corners of installation of forward wheels>> Convergence of wheels The convergence of wheels can be regulated on cross-section steering drafts instead of as was earlier on Volkswagen where it was possible to make adjustment only on the left cross-section steering draft. A convergence of wheels measure in the usual way, and it is necessary to pay attention that values are given in degrees and minutes. Wheels should stand freely. Digital value of a convergence is specified in the table of adjustments and control.
The steering should stand precisely on the average situation (movement on a straight line). For adjustment of a convergence of wheels weaken lock-nuts from both parties of the car, located on tips of cross-section steering drafts. Let's be turned to a protective cover of a steering, weaken a collar from outer side.
Rotate cross-section steering draft flat-nose pliers to the left or to the right. Both pipes of cross-section steering drafts move on identical size that the steering wheel remained in the central situation. Tighten lock-nuts of tips of cross-section steering drafts the moment of 55 N · m and again fix protective covers.
|
|