VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
- 2. VR6 engine
   - 2.1. Cнятие and installation
      2.1.1. Removal and transmission installation from the engine
      2.1.2. Additional operations if on the car the conditioner is established
      2.1.3. Engine mount
   + 2.2. Dismantling and assembly
   + 2.3. Head of the block of cylinders and valves
   + 2.4. Pistons and rods
   2.5. Block of cylinders
   + 2.6. Cranked shaft and radical bearings
   + 2.7. Drive of the mechanism of a gazoraspredeleniye
   2.8. Intermediate shaft
   2.9. Compression check in engine cylinders
   + 2.10. System of production of the fulfilled gases
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> VR6 engine>> Cнятие and installation>> Engine mount
At replacement of an engine mount use fig. 23 — 25. Follows поддомкратить the engine to unload separate elements of a suspension bracket.
Always observe the moments of an inhaling of bolts of fastening of support of an engine mount. Upon purchase of details of a suspension bracket and support remember that for a mechanical and automatic transmission they differ.
Adjustment of an engine mount is required only if the engine and a transmission were removed, and from the engine and its bearing beam the rezinometallichesky support was turned off. In order that it is correct to establish the engine make the following:
- turn on, and then again tighten by hand on 5–6 turns bolts of a support of an engine mount;

Fig. 24. The right engine mount in the disassembled condition. Moments of an inhaling of bolts of fastening of support of a suspension bracket: 1= 55 N · m; 2= 60 N · m




- shake the engine forward-back that it was leveled, and tighten bolts and nuts, observing the specified moments of an inhaling (see fig. 24 and 25 ).

Fig. 25. The right engine mount in the disassembled condition on the car with an automatic transmission. Moments of an inhaling of bolts of fastening of support of a suspension bracket: 1= 55 N · m; 2= 110 N · m; 3= 60 N · m