VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
- 16. Electric equipment
   + 16.1. Storage battery
   - 16.2. Generator
      16.2.1. Precautionary measures at work in power supply system
      16.2.2. Generator check
      16.2.3. Removal and generator installation
      16.2.4. Generator repair
   + 16.3. Starter
   + 16.4. Screen wipers
   + 16.5. Headlights
   16.6. Back lamps
   16.7. Replacement of lamps of forward indexes of turn
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema


Repair Sharan/Sharan Volkswagen>> Electric equipment>> Generator>> Removal and generator installation
Fig. 334. Details of the generator and its fastening on the 2,0-liter engine: 1 — bolts М8, 25 N · m; 2 — a tension roller; 3 — an arm; 4 — the natyazhitelny device; 5 — M8 nut, 30 N · m; 6 — a tension regulator; 7 — bolts of fastening of a regulator of tension, M4; 8 — a casing; 9 — bolts of fastening of a casing; 10 — the generator; 11 — poliklinovy a belt





The design of the generators established on the 2,0-liter engine and the VR6 engine, is presented on (fig. 334) and (fig. 335) respectively.

Fig. 335. Details of the generator and its fastening on the VR6 engine: 1 — bolt М8; 2 — an arm; 3 — a washer; 4 — a konusny bolt, 25 N · m; 5 — the generator; 6 — a tension regulator; 7 — bolts of fastening of a regulator of tension, M4; 8 — a casing; 9 — bolts of fastening of a casing; 10 — poliklinovy a belt; 11 — bolts М8, 25 N · m; 12 — M8 bolt, 25 N · m; 13 — a konusny bolt, 25 N · m




Removal of the generator carry out in the following order:
- remove "minus" a wire from AB conclusion. Unbend a cable from a polar conclusion of AB (to avoid their casual contact);
- remove driving poliklinovy a belt;
- disconnect from a generator casing the electric socket and a wire from the separate plug;
- unscrew bolts of fastening of the generator to an arm, take out them and remove the generator.
Installation of the generator carry out as it should be, the return to removal. Enclose poliklinovy a belt in flutes of pulleys and adjust its tension.