VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
- 16. Electric equipment
   + 16.1. Storage battery
   + 16.2. Generator
   + 16.3. Starter
   + 16.4. Screen wipers
   - 16.5. Headlights
      16.5.1. Replacement of lamps of headlights
      16.5.2. Removal and headlight installation
      16.5.3. Dismantling and headlight assembly
      16.5.4. Headlight adjustment
   16.6. Back lamps
   16.7. Replacement of lamps of forward indexes of turn
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Electric equipment>> Headlights>> Replacement of lamps of headlights
Lamps of headlights act in film from a motor compartment of the engine. Replacement of a lamp does not change a headlight adjustment.

Prevention
At replacement of lamps of headlights work in gloves that on glass of a lamp did not remain fatty traces from fingers as even insignificant fatty traces on a burning lamp lead to dimness of a flask and a fast exit of a lamp out of operation. If such traces are, remove them with alcohol.

Replacement of a lamp of a headlight is carried out in the following order:

Fig. 351. A type of a headlight from the back party: 1 — a clip; 2 — the electric socket; 3 — the boss of a lamp of a dimensional lamp; 4 — a headlight lamp; 5 — a clip clamp




Fig. 350. Separate elements of a headlight: 1 — the screw, 8 N · m; 2 — a lock clip; 3 — the headlight case; 4 — the ventilating device; 5 — a cover; 6 — the boss of a lamp of dimensional light; 7 — a dvukhnitevy lamp, H4; 8 — the filament lamp of dimensional light; 9 — a reflector; 10 — rubber sealing laying; 11 — a rasseivatel of a headlight; 12 — the fastening screw; 13 — the electric motor turning a reflector of a headlight




- remove from the party of a motor compartment a protective cover 5 (see fig. 350 ). For this purpose turn a cover to the left and remove it. Now the headlight looks like, shown on fig. 351 ;
- separate the electric socket 2 from the back party of a headlight;
- press a clamp of the 5th clip 1 and cast away a clip down;
- take a lamp of a headlight 4;
- establish a new lamp (work in gloves). At lamp installation "ledges" on a socle of a lamp should enter into fillets on a reflector;
- put on a clip 1 a socle of a lamp and latch a clamp 5;
- put on a cover and turn it clockwise.
After replacement of a lamp of a headlight check and if necessary make adjustment of headlights. We recommend to make adjustment of headlights on HUNDRED.
Replacement of a lamp of dimensional light
Replacement of a lamp of dimensional light is carried out in the following order:
- remove from the party of a motor compartment a protective cover;
- take a cartridge 3 (see fig. 351 ) with a lamp of dimensional light and a shtekerny block from the headlight case;
- replace a faulty lamp and move a cartridge with a new lamp and a shtekerny block into a reflector;
- put on a protective cover and turn it clockwise.