VW Sharan repair . Diesel engines: 1,9 l of TDI. + + - + + + - + + + + + + + + + + + + + + + + + + + + +
|
Repair Sharan/Sharan Volkswagen>> Two-liter engine (ADY)>> Cranked shaft and radical bearings>> Driving pulley of the hydrotransformer (for cars with AKP)
|
Fig. 147. A driving pulley of the AKP hydrotransformer with details: 1 — a podkladny washer; 2 — a strengthening washer; 3 — a fastening bolt
|
The driving pulley of the AKP hydrotransformer fastens six bolts 3
(fig. 147)
to a flange of a cranked shaft. Between bolts of fastening and a driving pulley there is a washer of strengthening 2 which has on an external edge скос and should be established to these skosy in the direction to a driving pulley.
Installation of a driving pulley carry out as follows:
- attach a driving pulley together with a washer of strengthening 2 to a flange of a cranked shaft six bolts of fastening 3 which should be turned by hand;
- previously tighten bolts of fastening of a driving pulley the moment of 30 N · m;
|
Fig. 148. Interval measurement between a driving pulley and a surface of the block of cylinders
|
- measure by a calliper distance from the block of cylinders to a driving pulley
(fig. 148)
. The received size should be in limits from 19,5 to 21,1 mm. If it not so, establish a podkladny washer 1 (see
fig. 147
);
- tighten bolts of fastening the moment of 60 N · m then tighten them for 90 ° (on a turn quarter).
|
|