VW Sharan repair. Diesel engines: 1,9 l of TDI.+ 1. Introduction + 2. VR6 engine - 3. Two-liter engine (ADY) 3.1. Removal and installation + 3.2. Dismantling and assembly + 3.3. Head of the block of cylinders and valves + 3.4. Pistons and rods 3.5. Block of cylinders + 3.6. Cranked shaft and radical bearings + 3.7. Drive of the mechanism of a gazoraspredeleniye 3.8. Adjustment of a tension of a driving belt of units of the engine 3.9. Intermediate shaft 3.10. Compression check in engine cylinders 3.11. System of production of the fulfilled gases 3.12. Cleaning system with absorbent carbon application 3.13. System of a retsirkulyatsiya of the fulfilled gases + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of the VR6 engine + 7. Simos system of injection of fuel of the 2,0-liter engine + 8. Ignition system + 9. Coupling + 10. Mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. Hydraulic booster of a steering + 13. Forward suspension bracket + 14. Back suspension bracket + 15. Brake system + 16. Electric equipment + 17. Diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. Power supply system of the diesel engine and turbokompressor + maintenance Card + Specifications and characteristics + Elektroskhema |
Repair Sharan/Sharan Volkswagen>> Two-liter engine (ADY)>> Intermediate shaft
For removal of an intermediate shaft 8
(fig. 158)
it is necessary to remove the engine from the car.
To remove an intermediate shaft, it is necessary to remove a drive of the oil pump as the pump is put in action by intermediate shaft. After removal of the distributor of ignition and parts of a drive of the mechanism of a gazoraspredeleniye the intermediate shaft becomes available, it is possible to unscrew bolts of its fastening and a shaft to take.
The flange of a sealing ring has a returnable opening and should be established taking into account it. The flange defines an axial gap of a shaft and should be replaced, if the axial gap makes more than 0,25 mm. The O-shaped sealing ring creates tightness of a flange from the block of cylinders.
If the holder of an epiploon was turned off, it is necessary to replace an epiploon with the new. Installation of an epiploon of an intermediate shaft is carried out similar to installation of a forward epiploon of a cranked shaft. Bolts of fastening of the holder of an epiploon at assembly it is necessary to tighten the moment of 25 N · m.
|
|