VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
- 19. System of cooling of the diesel engine
   + 19.1. Cooling liquid
   + 19.2. Radiator and fan
   - 19.3. The pump of cooling liquid
      19.3.1. Removal and installation
      19.3.2. Repair of the pump of cooling liquid
      19.3.3. Poliklinova belt
   19.4. Thermostat
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema

Repair Sharan/Sharan Volkswagen>> System of cooling of the diesel engine>> The pump of cooling liquid>> Poliklinova belt
Poliklinova the belt is necessary for removing for access to the pump of cooling liquid, the generator or a pulley of a cranked shaft.

Fig. 469. For weakening of a tension of a poliklinovy belt turn a tension roller in the direction specified by an arrow

Establish a wrench on a nut of a tension roller and turn a key so that to weaken a tension of a poliklinovy belt (fig. 469) . Remove poliklinovy a belt.
Examine poliklinovy a belt: on it there should not be damages, cracks. Damaged replace. Again establish a tension roller as it was described, put on poliklinovy a belt, establish a roller on poliklinovy a belt. Edges should coincide with fillets, and the belt should settle down on the pulley center.

Do not pull poliklinovy a belt at installation by a screw-driver or any lever on pulleys, so a belt can lose durability at once.