VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
- 11. Shaft of a drive of wheels
   - 11.1. Removal and installation of a power shaft
      11.1.1. On the car with a mechanical transmission
      11.1.2. On the car with an automatic transmission
   11.2. Repair of a power shaft
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema


Repair Sharan/Sharan Volkswagen>> Shaft of a drive of wheels>> Removal and installation of a power shaft>> On the car with a mechanical transmission
Remove a decorative cap of a wheel and unscrew bolts of fastening of a wheel;
- will hang out a forward part of the car;
- remove a wheel;
- having fixed a wheel nave in motionless situation, unscrew a bolt of fastening of a shaft.
Removal of the left power shaft
Remove protection of the engine;
- separate steering draft with the lever on a rotary fist;
- disconnect draft of the stabilizer of cross-section stability from an amortizatorny rack;
Fig. 259. The spherical support fastens to a rotary fist in a place specified by an arrow





- unscrew two bolts located in the lower part of a rotary fist (fig. 259) . Unbend an axis head from an amortizatorny rack outside and fix in motionless situation. To avoid damages, disconnect a brake hose and distributing of wires of the sensor of frequency of rotation of ABS from fastening on an amortizatorny rack;
Fig. 243. Extraction of a power shaft





- short breakthrough pull out a power shaft from a transmission (see fig. 243 ), it is possible to use mount;
Fig. 260. To extend a power shaft from gearing with the case of the bearing of a nave of a wheel, shift the case of the bearing of a wheel outside, having at the same time pulled a power shaft in an opposite direction





- turn out a bolt from a semi-axis end face, and then squeeze out and take a semi-axis from a wheel nave (fig. 260) . Do not bend the hinge too strongly, the corner on which it it is possible not should to bend to be more than 18 °.