VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
- 12. Hydraulic booster of a steering
   + 12.1. Steering drive
   - 12.2. Replacement of cross-section steering drafts
      12.2.1. Replacement of a head of cross-section steering draft
      12.2.2. Replacement of all cross-section steering draft
   + 12.3. Hydraulic system
   12.4. Hoses, pipelines
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Hydraulic booster of a steering>> Replacement of cross-section steering drafts>> Replacement of a head of cross-section steering draft
After replacement of cross-section steering draft or a head of cross-section steering draft carry out adjustment of a descent disorder of wheels:
- remove a forward wheel;
- keeping cross-section steering draft for a shestigrannik, fix it in motionless situation. Weaken a lock-nut of cross-section steering draft;

Fig. 264. Removal of a spherical support of cross-section steering draft





- unscrew a nut of fastening of a head of cross-section steering draft on a soshka of a wheel and a stripper separate connection (see fig. 264 );
- remove a head of cross-section steering draft, considering thus quantity of turns which were required for its removal;
- if it is necessary to replace a hinge cover:
- remove collars and pull together the goffered cover;
- put on a new cover for the acting end of cross-section steering draft and establish on it new collars. After that it is required to carry out adjustment of a descent disorder of wheels;
- establish a new head of cross-section steering draft and wrap it on that quantities of turns on which the old was twirled;
- clear a bolt of a head of cross-section steering draft and insert it into a wheel soshka. Put on it new самоконтрящуюся a nut and tighten it the moment of 30 N · m. From final situation tighten it for 90 °;
- inspect a descent disorder of forward wheels (see section 13 «Forward suspension bracket»). Pay attention to that the safety goffered cover was not braided. Tighten a lock-nut on inside of the hinge of cross-section steering draft the moment of 55 N · m.