For removal of cross-section steering draft remove the ball hinge of a gear lath. The special key (No. 1332/8) or rather big wrench is for this purpose used.

Fig. 268. Length of cross-section steering draft (size a)

Measure length of all cross-section steering draft, including a head of cross-section steering draft (a distance on fig. 268 ). The nominal size makes 378,5±1,0 mm;

- release a cover of the hinge and shift it back on cross-section steering draft;

Fig. 269. Removal of the spherical hinge of cross-section steering draft from a gear lath. On a key 1 (1332/8) establish a dinamometrichesky key 2 (1332)

- clamp the steering mechanism in a vice (fig. 269) and establish the key represented there on the spherical hinge of cross-section steering draft. Remove cross-section steering draft;

- establish new cross-section steering draft, maintaining the distance measured earlier, and again twist it in a gear lath the moment of an inhaling of 70 N · m. Do not put the liquid fixing carving connection, on a carving of cross-section steering draft;

- establish a hinge cover on the case of a gear lath.

- adjust a descent disorder of forward wheels.