VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
- 5. Cooling system
   + 5.1. Cooling liquid
   + 5.2. Radiator and fan
   + 5.3. Pump of water cooling of the 2,0-liter engine
   + 5.4. Pump of water cooling of the VR6 engine
   5.5. Thermostat of the 2,0-liter engine
   5.6. VR6 engine thermostat
   5.7. Poliklinova belt
   5.8. The circulating pump of cooling liquid
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema


Repair Sharan/Sharan Volkswagen>> Cooling system>> The circulating pump of cooling liquid
In system of cooling of the engine there is an additional electric circulating pump of cooling liquid. On the electroscheme it is designated as V51. The circulating pump works constantly, and besides cools the engine after its stop so the hot engine is cooled still some time after ignition switching off. Thus as usual carry out the corresponding check of a condition of hoses, clips of hoses etc.
Check of operability of the additional pump, and also turning on of the fan after a stop of the engine carry out in the following order:

Prevention
At carrying out check of operability of the additional pump ignition should be switched off.


Fig. 196. The Shtekerny block (it is shown by an arrow) which should be disconnected at check of operation of the pump for engine cooling after its stop





- disconnect a shtekerny chetyrekhshtyrkovy block (fig. 196) of the temperature sensor of turning on of the fan from the thermostat case;
Fig. 197. Check of the temperature sensor for turning on of the fan of system of cooling after a stop of the engine and the water pump: «1», «2», «3» and «4» — contacts





- connect by means of a piece of a wire contacts «1» and «3» (a brown-red cable and a fulvous cable) (fig. 197) ;
- thus should earn the fan of system of cooling and the circulating pump of cooling liquid;
- if the fan and the circulating pump did not earn, then there are other malfunctions which should be revealed on HUNDRED Volkswagens by means of the corresponding measuring equipment.