VW Sharan repair. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
- 6. System of injection of fuel of the VR6 engine
6.1. Precautionary measures at work on repair of system of injection
6.2. A principle of work of ESUD under various conditions
+ 6.3. Injection system
+ 6.4. Malfunctions of system of injection
+ 6.5. Work on repair and service of system of injection
6.6. Cable of a drive of a butterfly valve
+ 6.7. Electric fuel pump
6.8. Fuel filter
6.9. The fuel level sensor in a tank
6.10. Air filter
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
Мачтовый подъемник купить в москве смотрите на s-pod.ru.
Repair Sharan/Sharan Volkswagen>> System of injection of fuel of the VR6 engine>> Cable of a drive of a butterfly valve
The cable of a drive of a butterfly valve is very sensitive to damages. At carrying out any works in a motor compartment of the car watch that it not to bend.
Probably, you also should not replace ever a cable of a drive of a butterfly valve on new, however it needs to be removed at carrying out some works. For this purpose unscrew a support and unhook the cable end from sector on the case of a butterfly valve which is fixed by means of a bracket. The tension of a cable is provided by means of a bracket on an arm which thus it is not necessary to remove.
After installation of a support and fixing of the end of a cable ask the assistant to press a pedal of "gas" and be convinced that the sector of a butterfly valve does not move more than on 1,0 mm.