VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
- 8. Ignition system
   8.1. General description and work of system of ignition
   + 8.2. Main knots and details of system of ignition
   8.3. Precautionary measures at work on repair of system of ignition
   + 8.4. Work on repair and service of system of ignition
   + 8.5. Distributor of ignition of the 2,0-liter engine
   8.6. Adjustment of the moment of ignition of the 2,0-liter engine
   + 8.7. Spark plugs
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema

Правильной эксплуатации сетевого помехоподавляющего фильтра ЛФС 40.

Repair Sharan/Sharan Volkswagen>> Ignition system>> Precautionary measures at work on repair of system of ignition
At work on repair and service of system of ignition to avoid traumas and damage of the system, observe the following precautionary measures:

People with a pacemaker are forbidden to carry out works on repair of system of ignition of the engine.

At AB removal from an electronic memory the codes written down in it, for example, a radio tape recorder code are erased. Before a detachment of wires from AB check, whether you at yourselves have a protective code of a radio tape recorder.

Surely observe our instructions on precautionary measures from the section «Injection system».

- never disconnect electric wires and do not touch them if the engine works or it is scrolled by a starter;
- disconnect and connect electric wires of system of ignition only at the stopped engine. At connection of measuring devices it is necessary to switch off also also ignition;
- before disconnecting a shtekerny block of EBU it is necessary to wait at least 20 with the ambassador of switching off of ignition. Otherwise it is possible to damage EBU;
- engine start-up by the prikurivaniye method from other car should last no more than 1 mines, at tension no more than 16,5 In;
- at car towage to avoid damage from ignition system always disconnect a shtekerny block of EBU;
- before carrying out electrowelding works it is necessary to disconnect wires from AB and a shtekerny block from EBU;
- use only the recommended wires of VN for ignition system;
- at replacement a begunka of the distributor of ignition, use only the ordered begunok (only for the 2,0-liter engine). Begunok is designated as R1.