VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
- 9. Coupling
   9.1. Coupling removal
   9.2. Check of a technical condition and coupling control
   9.3. Coupling installation
   + 9.4. Drive of switching off of coupling
   9.5. Malfunctions of coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Coupling>> Coupling installation
Installation of coupling is carried out in return sequence taking into account the following:
- if establish old coupling, watch that all earlier put labels coincided. It is possible to establish new coupling in any situation as it did not get used yet;

Fig. 230. A centering of a conducted disk





- to a centering of a conducted disk concerning a flywheel it is applied, simulating shlitsevy the end of primary shaft of a transmission, VW 3190 opravka (fig. 230) . For a centering it is possible to use an old primary shaft of a transmission;
- bolts of fastening of a casing of coupling to a flywheel wrap evenly cross-wise and tighten them the moment of 25 N · m. Thus the flywheel should be stopped a clamp in motionless situation. On HUNDRED "Volkswagens" VW 3067 clamp (see fig. 230 ) is for this purpose used;
- after installation on the transmission engine, check quality of work of coupling.