VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
- 2. VR6 engine
   - 2.1. Cнятие and installation
      2.1.1. Removal and transmission installation from the engine
      2.1.2. Additional operations if on the car the conditioner is established
      2.1.3. Engine mount
   + 2.2. Dismantling and assembly
   + 2.3. Head of the block of cylinders and valves
   + 2.4. Pistons and rods
   2.5. Block of cylinders
   + 2.6. Cranked shaft and radical bearings
   + 2.7. Drive of the mechanism of a gazoraspredeleniye
   2.8. Intermediate shaft
   2.9. Compression check in engine cylinders
   + 2.10. System of production of the fulfilled gases
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> VR6 engine>> Cнятие and installation>> Additional operations if on the car the conditioner is established
Prevention
By no means it is impossible to open a cooling contour as hit on skin of a coolant can lead to frostbite.

Specially trained personnel with use of special devices can carry out this work only. Only on HUNDRED it can be lowered and pressure in the conditioner is again created. If it is necessary to dismantle the engine at the established conditioner, remove the air compressor and a wire adhere it sideways so that hoses were not tense.

Prevention
Hoses of the conditioner are very sensitive to a break therefore at removal of the compressor be very careful.

To reach the compressor, it is necessary to remove the generator and to disconnect brackets of fastenings of hoses for cooling liquid of the conditioner.