VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
- 18. System of greasing of the diesel engine
   18.1. Removal and installation of an oil case
   + 18.2. Oil pump
   18.3. Oil filter
   18.4. Check of pressure of oil
   18.5. Oil radiator
   18.6. Replacement of engine oil
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> System of greasing of the diesel engine>> Removal and installation of an oil case
The oil case can be removed on the established engine.
Merge engine oil.
Remove protection of a case.
Unscrew an oil case and remove case laying if it remained on it.

Fig. 452. A type of an oil case and the disassembled oil pump: 1 — a directing plate; 2 — a maslopriyemny pipe; 3 — a bolt of a maslopriyemny pipe, 10 N · m; 4 — a sealing ring, 10 N · m; 5 — the case of the oil pump; 6 — gear wheels of the oil pump; 7 — a cover of oil pumps with the reduktsionny valve; 8 — a short bolt of a cover, 10 N · m; 9 — a long bolt of a cover, 25 N · m; 10 — an oil case; 11 — a sealing ring (always replace on new); 12 — a stopper of a drain opening, 30 N · m; 13 — a bolt of fastening of an oil case, 25 N · m





On fig. 452 fastening of an oil case is shown. Installation of an oil case is carried out in sequence, return concerning removal process. Pay attention to the next moments:
- carefully clear surfaces of contact of the block of cylinders and an oil case;
- evenly cross-wise tighten bolts the moment of 25 N · m;
- if you did not make filter replacement, fill in in the engine of 4,0 l of oil. Otherwise fill in in the engine of 4,2 l of oil. Remember the provided recommendations of rather excessive amount of engine oil in the engine. Certain instructions are provided in subsection 4.6 concerning use of engine oils to which also it is necessary to pay attention.