VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
- 15. Brake system
   + 15.1. Adjustment of brake system
   + 15.2. Disk brakes of forward wheels
   + 15.3. Brakes of back wheels
   15.4. Processing of brake disks
   - 15.5. Main brake cylinder
      15.5.1. Removal and installation of the main brake cylinder
      15.5.2. Repair of the main brake cylinder
   15.6. Check of the vacuum amplifier of a brake drive
   15.7. Pumping of brakes
   + 15.8. Parking brake
   + 15.9. ABS system (anti-blocking brake system)
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema


Repair Sharan/Sharan Volkswagen>> Brake system>> Main brake cylinder>> Repair of the main brake cylinder
Fig. 327. Fastening of the main brake cylinder: 1 — a tank cover with plugs of the sensor of emergency level of brake liquid; 2 — a float; 3 — a tank; 4 — connecting plugs; 5 — a nut, 25 N · m; 6 — the main brake cylinder; 7 — a sealing ring; 8 — a flange of fastening of a tip of a hose; 9 — the vacuum amplifier





Repair of the main brake cylinder in case of malfunction consists in its replacement assembled on the new. The unique elements which are subject to replacement, are the connecting plug 4 (see fig. 327 ), in case of detection of traces of leakage of liquid, and a sealing ring 7 between the main brake cylinder and the vacuum amplifier.
At replacement of connecting plugs execute the following operations:
- open a cover of a tank and by means of a siphon pear pump out from it liquid;
- by means of a screw-driver shake to the right-to the left a tank and carefully remove it;
- take connecting plugs;
- new connecting plugs grease with brake liquid and insert them into the main brake cylinder;
- carefully establish a tank;
- restore liquid level in a tank and pump over hydraulic actuator system.