VW Sharan repair. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
- 5. Cooling system
+ 5.1. Cooling liquid
- 5.2. Radiator and fan
5.2.1. Cover of a radiator and radiator check
5.2.2. Removal and radiator installation
5.2.3. Check of the fan of system of cooling
5.2.4 Check of the sensor of temperature of the remote thermometer
+ 5.3. Pump of water cooling of the 2,0-liter engine
+ 5.4. Pump of water cooling of the VR6 engine
5.5. Thermostat of the 2,0-liter engine
5.6. VR6 engine thermostat
5.7. Poliklinova belt
5.8. The circulating pump of cooling liquid
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
Repair Sharan/Sharan Volkswagen>> Cooling system>> Radiator and fan>> Cover of a radiator and radiator check
The radiator serves for branch of warmth from cooling liquid as an air stream.
The system of cooling of the engine is under pressure. A radiator cover with laying tightly close a radiator, but thanks to specially picked up spring which has been built in a cover in case pressure in system of cooling rises to 140 — 180 kPas, the cover of a radiator opens. Pressure in system of cooling raises because of expansion of cooling liquid that leads to boiling temperature increase.
Check of a cover of a radiator also is carried out by means of the delivery pump VW1274 (fig. 186) .
Tighten the pump VW1274 to a cover (see fig. 186 ) and increase with its help pressure until the cover will not open. The pressure size at which there should be a cover opening, should be between 140 and 180 kPas. If size another, it is necessary to replace a radiator cover.