VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
- 5. Cooling system
   + 5.1. Cooling liquid
   + 5.2. Radiator and fan
   + 5.3. Pump of water cooling of the 2,0-liter engine
   - 5.4. Pump of water cooling of the VR6 engine
      5.4.1. Removal and installation
      5.4.2. Repair of the water pump
   5.5. Thermostat of the 2,0-liter engine
   5.6. VR6 engine thermostat
   5.7. Poliklinova belt
   5.8. The circulating pump of cooling liquid
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Cooling system>> Pump of water cooling of the VR6 engine>> Repair of the water pump
VR6 engine
The water pump is not subject to repair, therefore at failure detection replace it with the new.
2,0-liter engine
The water pump cannot be repaired, therefore in a case in it of malfunction, replace it with the new.

Fig. 188. Pump of water cooling of the 2,0-liter engine in unassembled form: 1 — a bolt, 25 N · m; 2 — a pulley; 3 — a bolt, 10 N · m; 4 — the water pump; 5 — laying, replace; 6 — the thermostat; 7 — an O-shaped sealing ring, always on replacement; 8 — the connecting union; 9 — a collar; 10 — a cover of the case of the thermostat; 11 — a pulley of a poliklinovy belt





For replacement of the pump unscrew the case of the thermostat and take out the thermostat 6 (see fig. 188 ). Turn out bolts of 3 fastenings of the pump from its case and remove the pump. Remove laying 5 between two half of the case of the pump. Before tightening the pump to the case, establish new laying, replace an O-shaped sealing ring of the case of the thermostat. Can be removed and the details shown on (see fig. 188 ) are respectively replaced only.