VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
- 15. Brake system
   + 15.1. Adjustment of brake system
   - 15.2. Disk brakes of forward wheels
      15.2.1. Check of thickness of overlays of brake shoes
      15.2.2. Removal and installation of forward brake shoes
      15.2.3. Dismantling and assembly of the brake mechanism of a forward wheel
      15.2.4. Removal and installation of a brake support of forward wheels
   + 15.3. Brakes of back wheels
   15.4. Processing of brake disks
   + 15.5. Main brake cylinder
   15.6. Check of the vacuum amplifier of a brake drive
   15.7. Pumping of brakes
   + 15.8. Parking brake
   + 15.9. ABS system (anti-blocking brake system)
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Brake system>> Disk brakes of forward wheels>> Removal and installation of a brake support of forward wheels
The bolts, fixing brake supports, are wrapped by rather high moment of an inhaling: forward supports — 200 N · m, back — 110 N · m. Bolts of fastening of brake supports can be used further, carefully them having cleared. In case of replacement of bolts of fastening use only firm bolts from Volkswagen.
Removal of a brake support carry out in the following order:
- weaken bolts of fastening of forward wheels, put a forward part of the car on a support and remove wheels;
- remove brake shoes and tie up to a body a piece of a wire a brake support;
- if it is necessary, disconnect a brake hose from the cylinder case;
- turn out the top and bottom bolts of fastening of a brake support to a rotary fist.
Installation of a brake support carry out as it should be, the return to removal, thus:
- bolts of fastening of a brake support to a rotary fist tighten the moment of 200 N · m;
- watch that the brake hose was not overwound or will bend and did not concern car details;
- after installation of a brake support restore level in a tank and pump over hydraulic actuator system.