VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
- 17. Diesel engine
   17.1. Removal and installation
   + 17.2. Dismantling and assembly
   + 17.3. Head of the block of cylinders
   + 17.4. Driving belts — poliklinovy and gear
   + 17.5. Shatunno-piston group
   + 17.6. Intermediate shaft
   17.7. Flywheel
   + 17.8. Camshaft and camshaft epiploon
   + 17.9. Cranked shaft and radical bearings
   - 17.10. Block of cylinders
      17.10.1. Measurement of openings of cylinders
      17.10.2. Check a privalochny surface of the block of cylinders
   17.11. Compression check in engine cylinders
   17.12. System of production of the fulfilled gases
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Diesel engine>> Block of cylinders>> Check a privalochny surface of the block of cylinders

Fig. 402. Check of a head of the block of cylinders on deformation by means of a measuring ruler and щупа





Surface of the block of cylinders check on deformation by the way similar to check of a head of the block of cylinders (see fig. 402 ). Measure the block of cylinders in the longitudinal, cross-section direction and on a diagonal. Thus should not enter щуп in the thickness more than 0,1 mm.