VW Sharan repair

. Diesel engines: 1,9 l of TDI.
- 1. Introduction
   1.1. New VW Sharan
   1.2. Car identification
   1.3. General recommendations about car repairs
   1.4. Conditions of work and the used tool
   1.5. Correct lifting of the car
   + 1.6. Works on repair and service
   1.7. Lubricants, hermetics, Loctite
   1.8. Corrected addresses with carving connections, bolts, nuts
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Introduction>> General recommendations about car repairs
All descriptions in the present repair manual are rather clear and simple. The help tables provided in the end of the book, are very important and should be used at work on repair and car service as at the description of separate processes all necessary sizes and data are not always given in the text of the book, and this information should be specified according to tables. Especially it is important at verification of data for concrete model to exclude mistake possibility.
At work on repair and service of the car carry out the following recommendations:
- screws and nuts should be pure and slightly greased. Always check a carving of nuts and bolts that on it there were no damages. If necessary use new screws or nuts;
- always replace the removed being self-stopped nuts with the new;
- always observe the specified moments of an inhaling of carving connections. Values of the moments of an inhaling are broken on groups, according to sections of the real management that allows to find necessary sizes easily;
- at assembly replace all sealing laying, epiploons, lock washers, шплинты and About-shaped rings (round rings). It is also necessary to replace sealing rings of shaft and radial consolidations of shaft in case the shaft was taken from a sealing ring. Before installation it is necessary to cover a surface of a sealing ring with greasing. At its installation it is necessary to pay attention to that the greased party looked in that direction, oil or greasing from where can follow;
- special attention give to reliable fixing of the car in the lifted condition, using, whenever possible, trekhnogy false support;
- greasing, oil, anticorrosive protection of the bottom of a body and all mineral substances aggressively affect rubber parts of the chassis and brake system. It is impossible to allow hits of similar substances, and also fuel, especially on rubber parts of hydraulic system. For cleaning of brake system use only brake liquid or alcohol. However do not forget thus that brake liquid can spoil a paint and varnish covering of the car;
- after carrying out repair surely it is necessary to check serviceability of work of systems and car units at car movement.