VW Sharan repair

. Diesel engines: 1,9 l of TDI.
- 1. Introduction
   1.1. New VW Sharan
   1.2. Car identification
   1.3. General recommendations about car repairs
   1.4. Conditions of work and the used tool
   1.5. Correct lifting of the car
   + 1.6. Works on repair and service
   1.7. Lubricants, hermetics, Loctite
   1.8. Corrected addresses with carving connections, bolts, nuts
+ 2. VR6 engine
+ 3. Two-liter engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Introduction>> Correct lifting of the car

Fig. 7. A jack installation site on a forward part of a body





Lifting of the car is carried out by means of a jack from a set of the driver's tool, a garage jack or the stationary lift on HUNDRED. Jack installation sites from each party of a body have the corresponding strengthened seats. For a raising of a forward part of the car it is necessary to establish a jack under the strengthened seat (fig. 7) .
Before carrying out lifting of the car tighten the parking brake and enclose an emphasis under a forward and back wheel from the opposite side of the car.
When using a garage jack or the lift use the same points of lifting on a car body.
Be surely convinced of that soil under a jack or support rather firm, and support will not leave to the earth under weight of the car. To avoid it under a heel of an added jack or under wheels of a garage jack it is possible to enclose a wide board which will not allow them to plunge into the earth.

Prevention
At all do not rest a jack for car lifting against the case pallet, a transmission, an auxiliary frame or a back axis.

Before lifting of a back part of the car include a reverse gear on a mechanical transmission or establish the selector lever in the provision "R" of a parking on an automatic transmission.

Fig. 8. Trekhnogiye false goats






False support (fig. 8) can be established to Trekhnogiye only under a lateral part of a body, but apply them follows carefully, undertaking all measures not to damage a car body.

Fig. 9. Special supports






It is necessary to pay attention that the probe by means of which the height of support is regulated, is enough прочен therefore do not use instead of it other details, for example, bolts. Special supports (fig. 9) for wheels or a repair platform are also intended for carrying out repair work under the car bottom.
At entrance on special supports be convinced that they are precisely before wheels to provide to the car at arrival the correct direction of movement. With a view of additional safety on such supports often do dredging for car wheels. It is necessary to remember that Sharan above the ordinary car therefore it is less steady.