For removal of a flywheel from a cranked shaft block it a clamp in a motionless condition and unscrew bolts of fastening of a flywheel which can be thrown out at once as always it is necessary to establish only new bolts of fastening of a flywheel.

Check a condition of a gear wreath and in case of damage of teeths replace a flywheel. If the flywheel has scratches or teases on a basic surface of a conducted disk of coupling, remove them with a pro-point.

The flywheel is dismantled on the established engine after transmission removal. Thus surely check, whether leaks engine oil through a back epiploon of a cranked shaft. In case of course replace an epiploon.

At flywheel installation fastening bolts at first wrap a hand, and then tighten them in turn cross-wise with the moment of an inhaling of 70 N · m. After that turn each bolt again cross-wise for 90 °.