VW Sharan repair

. Diesel engines: 1,9 l of TDI.
+ 1. Introduction
+ 2. VR6 engine
- 3. Two-liter engine (ADY)
   3.1. Removal and installation
   + 3.2. Dismantling and assembly
   + 3.3. Head of the block of cylinders and valves
   - 3.4. Pistons and rods
      3.4.1. Removal
      3.4.2. Measurement of internal diameter of the cylinder
      3.4.3. Check of pistons and rods
      3.4.4. Measurement of a gap of a rod
      3.4.5. Assembly of pistons and rods
      3.4.6. Installation of pistons and rods
   3.5. Block of cylinders
   + 3.6. Cranked shaft and radical bearings
   + 3.7. Drive of the mechanism of a gazoraspredeleniye
   3.8. Adjustment of a tension of a driving belt of units of the engine
   3.9. Intermediate shaft
   3.10. Compression check in engine cylinders
   3.11. System of production of the fulfilled gases
   3.12. Cleaning system with absorbent carbon application
   3.13. System of a retsirkulyatsiya of the fulfilled gases
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of the VR6 engine
+ 7. Simos system of injection of fuel of the 2,0-liter engine
+ 8. Ignition system
+ 9. Coupling
+ 10. Mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. Hydraulic booster of a steering
+ 13. Forward suspension bracket
+ 14. Back suspension bracket
+ 15. Brake system
+ 16. Electric equipment
+ 17. Diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. Power supply system of the diesel engine and turbokompressor
+ maintenance Card
+ Specifications and characteristics
+ Elektroskhema








Repair Sharan/Sharan Volkswagen>> Two-liter engine (ADY)>> Pistons and rods>> Measurement of a gap of a rod
This operation is in detail described in item 3.6.2. Measurement is carried out in the same way, as well as gap definition in radical bearings with помощъю a plastic wire of "Plastigage". If it is not present, it is necessary to measure internal diameter of bearings with the enclosed loose leaves and diameter of a shatunny neck of a cranked shaft.